Gateway GoIP 4

Gateway GoIP 4 Features and Its Setting

The Voip gsm gateway goip 4 is often used to work with the IP-PBX at 850-1900 MHz. This model is perfect for low-cost phone calls at offices. The equipment allows the system to connect GSM-IP-network and serves as a call receiving device.

Using this device, you can transfer calls from one format to another and arrange an inexpensive telephony. The device can do call forwarding and automatically select the optimal tariff. This helps significantly save on calls.

The 4-channel gateway can be used for VoIP-communication with an average load. Entrepreneurs note the convenience of the equipment because it makes it possible to simultaneously make up to 4 calls in the office. In addition, over time, there may be additional connections.

The most successful price and quality ratio attract users are to this equipment as a four-channel gateway is a bit more expensive than a one-channel device and less expensive than devices equipped with more ports. It usually costs from $940 to $1,470. But this is a notional amount, excluding additional charges for taxes, transportation, customs fees, and other expenses.

However, to efficiently communicate via GoIP 4, it needs the setting correct and connection, otherwise problems with the operation cannot be avoided. To this end, it is important to invite a good technician who can perform the correct installation and configuration of the device, and provide it with additional features: Subnet Mask, LAN Port, Call Settings, and Default Route.

Users, who independently install the equipment, run the risk of wasting time and money because they are going to have problems setting up the VoIP system correctly. It is hardly possible without the appropriate skills and knowledge. As a rule, if not set up properly, you need to reinstall your system because it does not recognize the voip gsm gateways, with the devices working incorrectly.

In addition, the independent set-up of GoIP takes the layman a lot of time, while the technician can spend about 15 minutes to handle it.

The most frequent errors when setting up the equipment independently are:

  1. Installation of inappropriate versions of firmware.
  2. Entering incorrect data to the command line.

 

In the first case, when the firmware is installed improperly, there will be no updates and a risk of “neglect” of Elastix recording. In the second case, it is important to correctly enter the data into the command line. There is no universal “recipe, it all depends on the amount of equipment to be connected and on the type of IP PBX.

Professionals usually carry out comprehensive testing of the voice quality parameters, connection speed, etc., immediately correcting all deficiencies. The VoIP system status must be perfect if you want to use a good telephone communication.

Leave a Reply

Your email address will not be published. Required fields are marked *